多线烟温感探测器FT103传统非编烟温一体报警器

多线烟温感探测器FT103传统非编烟温一体报警器
可配接一切多线报警主机,多用于出口或者传统老款消防系统(非编2总线)的维护更换,
可通过国内消防总线厂家的输入模块(电流型,报警之后,拉低电压,增大电流),接入消防系统.
多线型光电感烟火灾探测器(以下简称探测器)适用于商场、宾馆、商店 、仓库、电机房等民用及工业场所的火灾预报警。探测器具有灵敏度高、稳定可靠、耗电小、美观耐用、使用方便等特点。
注：探测器报警时将其两端的电压钳位在5V～11V之间。至于电流的大小则取决于控制器的限流情况，不允许直接用24VDC供电，否则探测器会因无限流电阻而烧坏。正常使用时与多线报警主机或卷帘门控制箱等设备配套使用。探测器报警后，需要通过断电的方式复
FT103 Conventional Smoke and Heat Detector, Operates by Advanced MCU Expert Algorithm Software.

Key Specifications/Special Features
They work perfectly with all conventional intelligent fire control panels
Dual LEDs for 360-degree visibility
Advanced MCU Expert Algorithm Software.
Easy installation and maintenance
Durable sensor head, no need for replacement
SMD circuit board design-satisfactory quality and reliability guaranteed

SPECIFICATIONS

Operating VoltageRange:             9 to 28VDC Volts Non-polarized

Standby Current:                   60uA @ 24 VDC

Maximum Alarm Current (LED on: ) 30mA @ 24 VDC

Operating HumidityRange:          10% to 93% Relative Humidity, Non-condensing

Operating Temperature Range:        -10 C to 50 C

Adjustable Sensitivity:             0.15-0.3dB/m

Height:                           55 mm installed in Base

Diameter:                               103 mm

Weight:                          5.5 oz. (155 g)